"HOLY" the Original - QO-100 2.4GHz - 2-4.5 turn Helix Dual feed - Bullseye LNB - NO ICECONE !
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HOLY back parts for use with Bullseye 10kHz TXCO LNB
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 490
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Re-designed the original back parts of HOLY helix feeder to fit on a Bullseye 10kHz TXCO LNB and beeing printable without supports.
For my printer the M112.5x3 threaded parts work best with the original cover. I also added a M112x3 and a M113x3 threaded version. I'd recommend printing the M112.5x3 thread first and test it and then decide to use it together with the corresponding main part or either go down to M112x3 or up to M113x3 parts if it doesn't fit.
BOM for this part of the feeder:
- Bullseye 10kHz TXCO LNB, like https://www.elektor.de/products/bullseye-10-khz-tcxo-lnb-for-qo-100
- Screws: 2x M4x25 + 2 M4 nuts (connect main+lower part), 3x M4x16 (helix holder + reflector anchor, for the anchor also a M4x10 is sufficient)
- CA superglue (thread + main part)
For printing, turn the parts to the correct site - main part on the flat side (where later the reflector is mounted on) and the threads with the two small alignment pins up. After printing glue the thread part onto the flat side of the main part, use the two small pins for alignment. Insert two M4 nuts into the lower part and use the M4x25 screws to connect it to the main part.
Use the reflector, helix holder, the cover and the helpers from the original model in the combination you need. I am using the HOLY_Cover_v3.0_2.5turn_short__DM4DS together with the HOLY_2.5Turn_Helix_holder_v3_1.5mmWireHoles_DM4DS_Diavolo and 1.5mm² wire.
No TX operation until now, but RX works fine (85cm dish + Neolec SDR + SDR console)