End cap for Resparked (Culiau) Customizer engraver pen - stop rolling, and hold lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little clip to go on the end of your Resparked Customizer, to stop it rolling around and to attach the lid when in use
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
The Resparked Customizer (previously known as Culiau) is a great little pen-shaped for engraving, sanding, filing etc. But I had two minor problems:
- it's perfectly cylindrical, so rolls around when you put it down;
- when you're using it, the cap doesn't clip onto the end of the pen, so you have to put that down somewhere and hope it doesn't roll away.
This is a little thing to solve both problems. Clip it on the end of the pen and it has one flat edge (no more rolling), and lets you clip the lid into it too.
It's best to insert a little piece of craft foam into each half to provide some friction. I thought this was a better approach than making the clip tighter and tighter, risking scratching the lovely chrome finish on the Engraver.
You can use it in either orientation. The ridge in the middle isn't symmetrical, but that's just a design tweak so that it prints without needing supports. It works either way round.
Print in PLA, 0.2mm is fine, brim definitely recommended.