Soda Stream Button
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Button lever on the older SodaStream Machines. I have found a number of them on here, but most are…
- Ocena
- 4,833 / 5
- Polubienia
- 19
- Pobrania
- 423
- Wydruki
- 6
- Wyświetlenia
- 2527
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Replacement Button lever on the older SodaStream Machines. I have found a number of them on here, but most are simplified and not designed to be replacements as much as short term fixes. This one will replace the original cracked or broken part and will connect via the same way the original did. I should mention, I run my machine with a large CO2 tank and do not use a back cover. So I have not checked clearance when rear cover is installed.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
No
Supports:
Yes
.16 (any should work)
Infill:
40-70%
Filament:
[
Any Any, but best would be PETG or ABS ](http://www.amazon.com/s?url=search-alias&field-keywords=Any+Any%2C+but+best+would+be+PETG+or+ABS&tag=thingiverse09-20) Any
Notes:
Make sure you have good layer adhesion. I printed this with Top of button down on bed, with majority of part supported.
May have to ream out holes depending on your printer.
How I Designed This
My SodaStream button finally cracked and it was either design a replacement or buy a new machine.
Category: Replacement Parts