1 / 8
Tube Cutter for water filter tubing (3/8", 1/4", & PTFE) — zdjęcie 1
1 / 8

Tube Cutter for water filter tubing (3/8", 1/4", & PTFE)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cut 3/8”, ¼”, and PTFE tubing.

Ocena
5 / 5
Polubienia
28
Pobrania
119
Wydruki
3
Wyświetlenia
484
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This cutter is easy to print, easy to assemble, and easy to use. It cuts 3 sizes of tubing: 

  • 3/8” (9.525mm) used in RO water systems
  • ¼” (6.35mm) used in RO water systems
  • PTFE (4mm)

Parts Needed

  • 1 single edged razor blade
  • 1 M3x20 screw
  • 1 M3 self-locking hex nut
  • 1 M3x8 screw
  • 1 M3 hex nut

Assembly

  • Slide the razor blade in from the end until the hole lines up. The inside end of the blade will slide onto the plastic guide.
  • Fasten with a M3x8 or 10 screw and hex nut. Note that one side has a round recess for the screw head and the other side has a hex recess for the nut. Tighten snugly to keep the blade from moving.
  • Slide the upper and lower plastic parts together so the hinge holes line up.
  • Fasten with M3x10 screw and self-locking nut. Note the round and hex recesses. Tighten enough to keep it from loosening up, but not so tight that it pinches and prevents the hinge from moving easily. (I prefer the self-locking nut for this, but you may substitute a non-self-locking nut; although it may loosen up with use.)

Usage

Slide the tube to be cut in from either side. The tubing hole is open on the top so you may easily see where the cut will be made.

The extra “fin” on the upper part slides into the slot on the lower part to guarantee good blade alignment into its cutting slot.

Printing

There are no special requirements. Use any filament. Needs no support. Standard settings are OK. I used PETG, a .6 nozzle, .32 layer height, 3 perimeters, 20% grid infill, and 500mm³ solid infill threshold.

Tagi