1 / 5
Lanard Shot Gun / Air Zone Triple Shot / Lanard Hand Cannon / Huntsman Pillager X12 Catch Mechanism — zdjęcie 1
1 / 5

Lanard Shot Gun / Air Zone Triple Shot / Lanard Hand Cannon / Huntsman Pillager X12 Catch Mechanism

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement catch mech for the Triple Shot. Altered from the original stock part.

Ocena
5 / 5
Polubienia
4
Pobrania
15
Wydruki
0
Wyświetlenia
176
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Replacement catch mechanism for the Triple Shot. Altered from the original stock part.

Certain aspects of the design have been simplified for easier 3D printing. The main catch body was prone to breakage due to the safety mechanism cuts housed inside, hence it has been deleted in favour for structural rigidity.

I have designed this part where a small notch have been cut in the rear portion of the catch that can hold the torsion spring in place, preventing slippages. Most who modify Triple Shots usually re-orientate the torsion spring, courtesy of “Don - Mr BadWrench” on NerfHaven (http://nerfhaven.com/forums/topic/17496-lanard-shotgun-the-right-way/?mode=linearplus), for higher spring loads.

Printing with at least 85% infill is recommended for increased rigidity, however most users will probably go 100% in line with other catch designs within the current 3D printed blaster ecosystem.

 

Tagi