155mm shell bottom joint ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ring to add to the bottom joint of the shell. Allows install magnets to join and keep shell seam mostly hidden.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
This adds into the existing model, to allow you to glue this at the top brim of the bottom section and it extends into the next section up. I drilled and set magnets on both pieces, so the shell can open to store things and this keeps it well aligned.
I printed with a brim since it's thin but might have been fine without. 15% fill. Same material as rest of shell.
6mm magnets worked but very near walls of shell to use this. 5mm may have been better. You'll need at least 8 magnets on each side to work, maybe more.