Wireless Charger Stand for Chargie Supercooled Charger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wireless charger stand for the "Supercooled Wireless Charger with Qi2."
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The linked wireless charger (https://chargie.org/product/chargie-supercooled-wireless-charger-us/) comes with a mount designed for car air vents, which works well for that purpose.
However, this setup is not practical for home use, as the charger cannot be properly stabilized and tends to tip over.
This is where my charger stand comes in:
The ball joint securely holds the charger, allowing it to be mounted in either a horizontal or tilted position.
Simply tighten the knurled nut to lock it in place at the desired angle.
Usage:
Place the charger onto the ball joint, adjust it to your preferred position, and tighten the knurled nut.
Print Settings:
- Printer: Creality K1
- Nozzle: 0.4 mm
- Filament: Creality Hyper PLA (black) with appropriate settings
- Walls: 3
- Infill: TPMS D-Cell, 60% (higher density at the ball shaft is recommended, as a tilted phone may exert force on it)
- Support: Not required
Print Time:
Approximately 35 minutes