Apple TV Remote 3rd Gen Wall or Under Desk Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remote holder for the 3rd Gen AppleTV (A2843) that can be mounted under a desk or on a wall.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
I created this as I wanted a holder that was form fitting but also had a notch for the side microphone button. I wanted the model to only allow for a small amount of the remote to stick out so I could mount it right up against the desk's edge. I also wanted holes in the front of the model so I could easily put in screws but used 45 degree angled diamonds so it would be easy to print in a vertical orientation.
This model should be printed in the orientation provided (opening facing up). My print settings were was follows:
- vertical orientation
- .20mm Quality
- 10% infill
- 3d honeycomb
- no support
- no brim
The screws used to mount the holder will need to be flush or below the wall so the head of the screw does not scrape the remote as it enters the holder. I modeled the holes based on #6 ¾" screws. I'm happy to tweak the model if needed for different requirements.
The model is mirrored for each use. Please make sure you grab the correct copy for your use case. The under desk mount is made to have the remote enter top-first so the notch is on the right side. The wall mount is made to have the notch on the left side so the remote can enter the holder bottom-first. I did not make the model with a notch on each side as I did not want the remote to be inserted in the wrong orientation for each use case.