One handed Contigo coffee mug holder/opener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Securely hold your Contigo coffee mug/water bottle and unscrew the lid with just one hand. Works with jars just as well
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 194
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution
I designed this model in preparation for having rotator cuff surgery on my dominant arm. during the multi week recovery, I would only have reliable use of my left arm. I poor coffee for my wife and I in the morning into Contigo mugs that autoseal and will not leak and take it to her in bed. The lids for these must be very secure and are tighter than most stubborn jars. They also do not work in traditional jar openers that screw onto a cabinet and use metal teeth to grab the lid of the jar.
combining a 6 inch trigger clamp with easily assembled 3-D printed parts and some anti-slip padding, you can open Contigo coffee, mugs, and water bottles and jars and prescription pill bottles with child proof tops with only one hand.
I have also been able to use this device to hold our Nespresso milk frother such that I can clean it out with a round brush between frothing sessions.
Bill of Materials
- Pieces of anti-slip mats
- 2 @ m3 hex nut
- 2 @ m3-10mm
Printing instructions
- Print each piece with the flat side down. Only the base plate requires any supports, and those are limited to the filleted edge.
- for the V brace and triangular pads 5 to 10% info is sufficient
- use three vertical walls for strength
- printed in PLA for rigidity
- print the base plate with 25% info
- V brace special instructions
- The V brace is designed with two captured M3 nuts. 2 insert the nuts into the print slice your model and then add a pause at the last open layer of the nuts (95mm).
- insert the two nuts and then resume printing
The model was designed for easy assembly.
Assembly instructions
- After printing each part, you can use them as templates to cut out the anti-slip mats.
- For the triangle shelf flip the part so the tab is up and cut the anti-slip mat with a sharp knife over a cutting board
- For the V brace cut a rectangle 195mm x 75mm
- For the base plate cut a rectangle 204mm x 200mm
- Superglue the anti-slip mats to the inside of the V brace and top of the triangle tables. I recommend not gluing the anti-slip mat under the base. The downward pressure used when opening jars and mugs should be sufficient to hold everything in place. If you do decide to glue it to the base, be sure to cut holes for the mounting screws.
- Insert the V brace square pegs into the square holes and screw in the M3 by? Screws to hold it securely. These will engage the captured nuts inside.
- The triangle tables can just be placed in their square holes. If the square peg breaks off, you can superglue them to the base directly.
- insert the 6 inch trigger clamp such that the handle side pad slots into the rectangle on the back of the knee brace. I find this easiest to do with the base on the table already the small cavity for the pad will help hold it in place for use.
- place the base on top of the anti-slip mat if you have not already.
Usage instructions
Watch the following video for usage tips for pill bottles, water bottles, frothers, etc.:
<insert youtube video>