TPU Vibration Damper & Spacer for Motorcycle Phone Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flexible TPU adapters to mount phone holders on 12mm or 13.5mm mirror stems, reducing vibration and solving clearaence.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a flexible TPU spacer designed to bridge the gap between thin motorcycle mirror stems (or windshield bars) and standard phone holder clamps.
Most phone holders are designed for handlebars with larger diameters. These adapters allow you to securely mount those holders onto thinner rods while significantly reducing engine vibration transferred to your phone.
I designed this for a Peugeot Django, but it is compatible with many scooters and motorcycles with similar setups.
Versions Included:
v1 (Standard): Designed for 12mm diameter mirror stems or accessory bars.
v2 (Asymmetric - New!): Designed for 13.5mm diameter bars.
Why Asymmetric? On some bikes (like the Django), the gap between the windshield plastic and the mounting bar is very tight. This version is offset to push the mount slightly away from the plastic, allowing bulky phone holders to fit without scratching the windshield.
Print Settings & Tips:
Material: MUST be printed in TPU (Flexible filament).
The flexibility is key: it allows the part to be squeezed tight by the clamp, creating a high-friction, non-slip grip that absorbs vibrations.
Infill: 10% Gyroid (provides the right amount of "squish").
Walls/Perimeters: 2 walls are sufficient.
Fuzzy Outside Skin: Increase friction