Filterwheel Counterweight for Touptek Camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small counterweight to reduce imbalace of filter wheel when using a rotator.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 236
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
A small tube ring for a Touptek 2600 camera which can be fitted with a long M8 screw to attach large 20mm washers as a counter balance for the filter wheel. This is useful if you use a rotator that will change the balance of the image train while shooting. With my CEM70 mount I could improve the guiding quite a bit with this.
I printed the tube ring with PLA and added ruthex 50xM5S treads on one half of the ring to fit the tube ring with M5 screws. You can use M6 srews and nuts instead. To avoid scratching of the camera I added some velours to the inside of the ring.
In the center hole, I put a long M8 stainless steel screw.
As weight I used 20mm stainless steel washers (see photos) and printed 20mm shims for the inside to keep them centered. There are a couple of shims, depending on the number of washers you need. The shims are fastened with M8 nuts.