1 / 5
Ancient Champion Juicer Repair (Ivory Cutter) — zdjęcie 1
1 / 5

Ancient Champion Juicer Repair (Ivory Cutter)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

After second carrot the cutting device did not revolve. The key engaging the flat spot on the axle was worn out.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
80
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The key engaging the flat spot on the axle was worn out. So to engage the two parts again for healthy fruit or vegetable juices I cut out a sqare from the worn out section and designed a new key to be inserted. 

I rebuilt the axlie with (here!: key on the axle) to check if that fits my cutout in the ivory cutter. Then after some file strokes I printed the new key. It had a little wedge effect to better clamp in the cutter. 

I ƒprinted on my Bambu X1C with PA6 Styx-12 (Formfutura). 4 perimeters 5 layers top and bottom, infill 85%. It came out pretty tight, some more file strokes and the key (50mm) could be put in to place with a few hammer strokes.

On the front of the ivory cutter I had to "Dremel" 5.5mm round as the cutter did not got until end position. This does not look nice, which does not matter. I considered these file and dremel-reworks in the design.

If you do this repair I recommend my procedure:

  1. Mark the place where the key is worn out.
  2. Mark with a Sharpie on the ivory cutter approx. 50mm depth (on outer corpus). So you know approx. how far to cut, file, chisel.
  3. Drill Ø4mm 50mm deep, 2x to cober approx. 8mmx4mm. Cut this out carefully with chisel, 9mm blade cutter, etc. 
  4. Try the cut-out hole with the TestPiece.stl (here in the download section).
  5. File, rework until the test-piece fits smoothly. Maybe use some organic oil for the test-piece, moving in and out.
  6. Print the Champion Juicer Key.stl and check the fit. It it is too tight, file either piece (key or ivory cutter-hole. If you feel that the key fits and jsut is a bit tight for the last 10mm, and you are confident to get it smashed in, then use some oil on the key and smash it into the ivoroy cutter.
  7. Now check the fit on the axle (flat spot). You might file a bit from the surface of the key to get a smooth fit. 
  8. If you had success, then congratulate yourself. You did a good job and saved a hundred bucks!

Explore my other Printables: https://www.printables.com/de/@Tritschi 

Tagi