Edifier S350DB Woofer + Speaker grilles

In the past few weeks I received 3 separate requests for the matching woofer grille for an older design I made earlier.
 

I had some spare time and decided to finish the woofer grille I had already started designing a long time ago. Since my woofer stands in a spot where damaging it is nearly impossible I never finished the project. I made a test print to see if it all fits together well, and I could put the parts together without the need of any tools. 

I designed the woofer grille in separate pieces which slot together very easily. I didn't use glue for mine, but you can always use some glue of course. I also altered the control speaker grille a bit so that the sound input selection at the front is no longer covered. 

I have calibrated all my printers and filaments really well, which makes putting printed parts together very easy. If you have not done this you might find that you need to use a file to get some parts to fit properly.. Calibrating and perfecting filament and print profiles takes some time, but it is well worth it!!

You will need 15x the “Rib” to complete the Woofer grille!!

Print settings:

• 0.2 layer height

• 5 walls, 5 top/bottom layer

• 20% infill

• No supports needed for the woofer parts

• Supports for the smaller speaker grilles is recommended

If you want to support my work, feel free to buy me a coffee :)

https://buymeacoffee.com/3dmadmesh