Crimper Die Adapter for Paladin Tools Crimp-All Crimper (or other similar size crimpers with replaceable dies)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had purchased a set of Dupont crimping dies (https://www.amazon.com/dp/B0774V8HXZ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2) for my Paladin Tool Crimp-all and didn't realize I bought one that was too small for it. I didn't want to wait again to buy another set of crimpers or the correct die for it, so I made this adapter. I am assuming it'll work for similar size dies but didn't need any other ones yet.
Print 2 of this for top and bottom. I used PETG as it's somewhat flexible. Other filaments might work too.
It goes in a little tight (so the bolt isn't needed). Easiest way is to put the die into the adapters, and put the adapter into the crimper. Then slowly close it while making sure they're aligned before completely closing. It works well for me.
If you print this, please leave some feedback. Leaving it out for others that might be in the same situation as I am.