Magnetic Travel Palette for 26mm Eyeshadow Makeup Pans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a magnetic palette case for 26mm makeup pans. It holds up to four pans.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have been wanting to pare down my travel makeup-kit to the size of a pencil case, but one issue that kept popping up was how to take a few different eyeshadow colors that would be enough for a fairly complete look, but still very efficient. Premade eyeshadow palettes tend to be too much with too many colors (9-pans and up) or too little (duos). 4 colors is about right, but eyeshadow quads are rare these days. Magnetic palettes were all too large and too flat, with a large footprint that doesn't fit in my little kit.
So I set out to make my own.
I ended up designing a clamshell with a print-in-place hinge. Each half holds two 26 mm pans, with magnets, and the closure is also magnetic. I have also added a mylar sheet that goes between the halves and protects the eyeshadows from fallout. The result is a very small, compact footprint that will fit a pocket or a small pouch, but holds four average-sized eyeshadow colors.
List of materials:
- Filament for your print
- 3mm x 2mm round magnets for the closure
- 20mm x 1mm round magnets for the pans
- 4 mil mylar for the shield (you could probably use thicker without much trouble)
- 4 magnetic 26mm makeup pans
I used Flashforge Burnt Titanium PLA to print mine, on a holographic print bed, but any PLA will do, and probably any filament that is strong and not too brittle. No support was needed. The clearance for the hinges is 0.2mm so make sure your printer is accurate enough!