Delta PMC-12V050W1AA IEC Inlet Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Box for the Delta PMC-12V050W1AA with an IEC inlet/switch/fuse and Anderson Powerpole output connector.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
https://deltapsu.com/en/products/panel-mount-power-supply/PMC-12V050W1AA
Picked up a few of these power supplies from a local ham for use with amateur transceivers. Ideally these would be mounted to a panel, but I couldn't pass up trying to make a tiny power supply that I could plug anything with an Anderson Powerpole in to.
The box is attached to the PSU with two M3x5mm screws into heat-set inserts. You could use self-tapping screws, just adjust the size of the holes accordingly. Be aware this configuration only mounts from one side and isn't the strongest, so keep this in mind when using and transporting. The next version of this model will most likely include more of a back-brace to take advantage of some other threaded holes.
I used this IEC plug/switch/fuse combo since it's what I had on hand: https://a.co/d/cpzqkoN. The model could be easily adjusted to accommodate other variants with screw mounting, may do this down the road.