Bumbag electronics enclosure extensions with DIN rail mounts for RatRig VCORE 4.0
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bumbag remix to allow for DIN rails instead of fixed mounting locations.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 495
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the bumbag by tg73. I wanted to use DIN rails so I could swap things out and rearrange them easily. This setup is for a 1st generation vcore 4.0 400. That means my printer routed the motor wires under the rear extrusion and through a hole in the back panel. This was changed in a future revision. Since mine was designed this way, it includes a bottom panel to route the wires into the lower bumbag enclosure. This is assembled using m3 screws and heat set inserts There is also a wire channel that attaches to the screw mounts so the motor wires never need to go into the chamber. Also, my printer uses 3 fans on the side of the electronics enclosure. A second revision of the electronic enclosure was released and I don't know if this will work with it.
This din rail mounts use m5 button head screws to hold them in place . There is a grid of holes for m5 heat set inserts for mounting flexibility. You don't need to use them all.
My printer uses 24v and 48v power supplies. I designed a cover for the high voltage wiring. It covers one din rail section in the bottom enclosure where I use din rail mounted wago blocks for all the mains connections. I have included that cover. I do not know if it will work with a single 24v power supply.
Since my printer is a 400, all of the holes are designed to align with that printer. You will have to drill additional mounting holes in the rear panel to mount this.
I did not intend to release this but due to people requesting it, I am posting it. It is not as clean as my other designs as it was remixed from an STL. Since it was only meant for personal use, you mileage my vary.