1 / 1
Bracket 59mm and hinge
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Love this pi mount but needed to go back a little more and wanted to angle it out some too. So I made this remix. Need…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Love this pi mount but needed to go back a little more and wanted to angle it out some too. So I made this remix. Need m3 x 20mm bolt and m3 nut for top hinge.. and just slid filament on the bottom hinge. Only need to tighten the top to keep the angle. I also added in a cable chain slot. Hope it helps someone.
Print Settings
Rafts:
No
Supports:
Yes
.2
Category: 3D Printer Parts