MLX90614 IR sensor for VPD measurements
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple little housing/mount for hanging a IR sensor above a canopy
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Taking use of the MLX90614 (DCC/BCC) sensor (GY-906) I can measure the actual leaf temperature for getting "LeafVPD" measurement with Mycodo.
You need to solder the wires onto the board (there is not enough height for Dupont pins!).
Design makes use of a dovetail joint on the bottom to keep the parts together and there is a recess for soldering/pins on the back of the PCB. Fits very tight/flush and your printer needs a good bit of calibration to get everything right ;-).
Pressure fit (using the screws) for a 5mm thick cable.
Print two, no need to mirror!
Hardware:
2 x M3x8mm (SHCS)
Print settings:
3 walls
4 top
4 bottom
20% infill
0.2mm layer height
P.S. take use of tree supports not on the buildplate, the holes don't need any support at all only the big overhang on top (and flip the print in the slicer so the dovetails are on the bottom).