Prusa XL Filament Sensor x6 (magnetic / weaker) w/ PC4-M10 fittings & PrusaSlicer text
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One sided filament holder for Prusa XL. Uses magnetic filament sensor concept. Fits PC4-M10 fittings
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 370
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
UPDATED FILE HERE IF THE OUT OF ORDER NUMBERS DRIVE YOU NUTS!
THIS FILE USES A CUSTOM FONT: HELVETICA NEUE (similar to prusa font) Install it before opening FILE!!
Started with IBNobody's x6 block, used tg73's concept of hole placement, though I did that work on IBNobody's block in Fusion 360
Added 3.3mm holes at a very specific depth (producing only 2-3 layers of print between the magnets and filament channel for maximum attraction. (depending if you use .15 or .20 mm layer height)
Added Filament sensor numbers to a “right” and “left” model within the .3mf file
Used these couplings:
3DMan PC4-M10 Male Straight Pneumatic PTFE Tube Push in Quick Fitting Connector
Used these magnets:
Hyooctt 80 Pieces 3x6mm Small Fridge Magnets for Crafts Refrigerator Whiteboard Kitchen Office Magnet
Filaments sensor LONGER cable for relocation
Digikey WM16512-ND / Molex 0151350506 (MUST BE REWIRED!!! 1-1, 2-2,3-3,4-4,5-5 as it comes “crossed”)
Text is in PrusaSlicer uses HELVETICA NEUE (similar to prusa font) Install it before opening FILE!!
Printed in Prusament PC Blend (black and orange)
Sliced using PrusaSlicer 2.9.1 with new color interlock and single perimeter outlines on all top and bottom surfaces.