Dell 65w Power Supply Wrap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A casing with cable channels for your power supply to keep it nice and tidy.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 572
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
*Before Printing make sure your power supply is about 47 x 106 x 28mm*
Tired of stuffing what feels like a mile long cable into your computer bag? This wrap can help you keep you bag, or backpack nice and tidy.
About the Print:
No hardware is required to assemble! Everything just clips together. There are two cable routes that will allow you to separate both cables. In each cable route is a notch that you can slide that cable in to keep it from unraveling. These notches are also useful if you don't want to use the full length of the power supply. You can just unwind the desired length and slide it into the notch.
I designed this because I thought it would be useful if you're using a laptop for work, school, or you just like to travel around with your laptop a lot. There wont be the usual rats nest in the bottom of your bag.
I hope you all enjoy the print! :)
Assembly Instructions:
- First print the 2 models. Print the models with the cable channels on the build plate. The lower housing will need to be printed with a brim or raft because of the small surface area on the build plate.
- Snap the power supply into the lower housing. There are clips that will keep it in place, but can be easily undone.
- Slide the upper housing over the lower one. Make sure the openings for the cables to come out line up. It may take a bit of force to clip them together.
- Wrap the cables around and enjoy!