1 / 1
Goblin - Plunger & Front for 38mm OD x 35mm ID Tube
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapted plunger & front for 38mm OD x 35mm ID plunger tube.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 367
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was graciously gifted a plunger tube. However, it didn't match exactly the suggested 1 ½" OD 1 3/8" ID tube. Instead, it was 38mm OD and 35mm ID.
To adapt for this, I enlarged the O-ring areas on the plunger & front so that it would seal. For my personal build, I added 2-3 rounds of plumber's tape but you may not need to.
For the plunger, I added an extra -123 O-ring.
Print Settings:
Use same print settings as the original.
Assembly:
All is the same as the original, except you can add an extra O-ring to the plunger.