Kumiki cube - prism Y
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Kumiki cube cut as an octagonal prism along the Y-axis.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution
Prism Y
This is a remix of my Kumiki cube. It is basically the same as the original, but with the sides cut off along the Y-axis. This makes it a prism with eight sides.
The original Kumiki cube can be cut along each axis. Here is a picture of the cube next to the three possible prisms.
3D printing
MK4, PLA, no supports, no Input Shaper, 0.05mm.
I use a Prusa MK4 with a 0.4 nozzle to print these at 0.05mm resolution. I noticed that adding 0.05mm to a gap may make a piece fall out, and removing 0.05 may make it really hard to assemble the cube/prism.
This is a 20 hour print.
Overhang!!
There is one overhang on the biggest piece when printing without supports. You may need to scrape this a teeny weeny little bit to make the center pieces fit.
Look for example to this piece from the original cube. The filament comes a bit too far (because gravity). This may prevent some pieces from fitting.
Version 2.1
I made a lot of these to improve the pieces fitting together, and to have a smooth surface on all sides.
Assembly
Here is a video on how to assemble this prism.
Though it is not that hard, so try it yourself for the most fun!