1 / 3
QIDI Q1 pro : minimalist top spacer and venting
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I mostly print PLA, PETG and TPU. Instead of having to remove the cover, I prefer raising it by 15 mm.
- Ocena
- 1 / 5
- Polubienia
- 14
- Pobrania
- 49
- Wydruki
- 1
- Wyświetlenia
- 229
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I mostly print PLA, PETG and TPU. Instead of having to remove the cover, I prefer raising it by 15 mm and leaving it on top the printer.
Here is a fast printed raiser...
Print it in TPU because it needs to be twisted to install and TPU is better to avoid vibrations when printing. Print it flat on the bed. No support.
Just install at least 2 of them if you only want to raise one side of the cover, or 4 of them for a better air flow.