Elegoo Neptune 2 Anti vibration feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed some anti vibration feet for my Elegoo Neptune 2, was getting a little ghosting on some of my prints, had a…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed some anti vibration feet for my Elegoo Neptune 2, was getting a little ghosting on some of my prints, had a look on Thingiverse but didn't see what I was looking for.
Also I had 16 bed leveling springs left over from upgrade, so designed feet with intention to use them up.
Note:- When assembled use vernier to get them same height.
You will need following 4off Neptune 2 Anti Vib Feet (T) 4off Neptune 2 Anti Vib Feet (B) 16 off springs (25mm) 16 off M4 Nuts 16 off Cabinet Door screws (M4 x 25mm)
Print Settings
Printer:
Elegoo Neptune 2
Rafts:
No
Yes
Resolution:
0.2
15
Filament: eSun PLA+ Black
Notes:
I used these settings
Temp 210
Bed temp 50
Speed 50
Tree supports (easier to remove)
Category: 3D Printer Accessories