Waterproof Housing Test (TPU O-ring)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Built this as a proof of concept for a waterproof housing using printed TPU as an o-ring.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 1166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Built this as a proof of concept for a waterproof housing using printed TPU as an o-ring.
Holes are to fit a 2.5 screw and has 3mm in the lid and about 2.5 mm of threading. O-Ring is to be printed in TPU. I test by printing 2 and filling1 with red food coloring and the other with a paper towel.
V1 Didn't work. Going to adjust model and see if I can make it better
V2 Is up, realized the mistake I made. Will test tonight.
V2 worked flawlessly for holding liquid in and for keeping liquid out. I had one that failed after about 6 hours but that was due to a small issue with my extrusion width. Adjusted and tested again with excellent results. Now using this method for some project boxes that will be outside.
Print instructions
Category: 3D Printing Tests