1 / 3
Sunlu S4 Prusa XL Hanger Kit — zdjęcie 1
1 / 3

Sunlu S4 Prusa XL Hanger Kit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows hanging of Sunlu S4 Filament dryer from the vertical side frames of the Prusa XL

Ocena
5 / 5
Polubienia
31
Pobrania
58
Wydruki
2
Wyświetlenia
896
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I recently added a 24" concrete paver under my printer and now my dryer wouldn't sit next to it.  So lets hang it!  I also wanted it to sit far enough away to allow the enclosure bellows to operate and to have the lid not interfere with the filament sensor.  Bonus, this allows for the tubing to “hide” behind the filament dryer for a neater appearance.  (I also moved all 4 filament exits to the end by the wall inside the dryer)

Each bracket requires (2) 3030 roll in T nuts.  I chose M4 size and used these:
https://a.co/d/fZiweKH  you will need 4 in total

Each bracket takes 2 screws.  4 total for the set of brackets
you will need:

(2) M4x12 standard Hex Socket Cap for the top hole
(2) M4x20 standard Hex Socket Cap for the bottom hole

After testing, PLA seems to be more than strong enough for this task.  Printed in Prusament Orange PLA.  *** However, after very long dryer run times, it seems it will soften the PLA just enough to allow the PLA to start to warp creating a slight lean-out effect.  Still supported, still holds, but a more temp resistant filament might be recommended.

The legs of the dryer do not allow it to slide too far either way as to let it tip off.  There is about a 1mm gap allowing it to slide freely if needed.

This really cleaned up my work area, and I hope it helps someone else.

 

Tagi