LusoSport JRD lightsaber measurement tool

Hello there!

This is my design of a measurement tool for LudoSport competitions.
The JRD can use it to quickly measure the length of the hilt(s) and blade(s) for the three weapons used in this awesome sport: long sabers, short sabers, and staffs.

If you don't know what LudoSport is, visit www.ludosport.net

It can be printed in place and it's foldable.
You can use 4x3mm magnets to keep it straight.

N.B. please check after printing that the measurements are correct, since it might vary according to the calibration of your printer.

I've also uploaded the Fusion360 design if you need to tweak something.
There are parameters for many measurements, so if you need to change the diameter or the length of the magnet, you can just change the parameters (ctrl+P).

I've used colored foam clay to add the details (model a tiny "spaghetti" and push it into the embossed).
Maybe also a 3D pen can be used. You can tweak the text and the line width in Fusion360.

I plan to release also a version with the labels as a separate body, so you can print with dual extruder.

Keep in mind that the design is big, it might require a brim to avoid warping.

You also need to increase the infill for the joints. You can do it in the whole model, or add a custom block for increased infill only in the joints.

This is compliant with the specification in ITR v3.5.1 - 17th, 2024

Long saber
- Hilt length: from 258 to 322 mm.
- Blade length out of the hilt: from 865 to 875 mm.

Short sabers
- Hilt length: from 178 to 262 mm.
- Blade length out of the hilt: from 595 to 605 mm.

Staff
- Hilt length: from 358 to 542 mm.
- Blade length out of the hilt: from 725 to 735 mm.