1 / 9
Belt clip for Philips Avent baby monitor (babyphone) SCD 560 — zdjęcie 1
1 / 9

Belt clip for Philips Avent baby monitor (babyphone) SCD 560

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

In principle, a baby monitor is a nice thing. Too bad that Philips decided to remove the belt clip for the current…

Ocena
0 / 5
Polubienia
1
Pobrania
28
Wydruki
0
Wyświetlenia
349
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

In principle, a baby monitor is a nice thing. Too bad that Philips decided to remove the belt clip for the current version of their DECT babyphones. So if the baby is sleeping and you want to get some stuff done, you still only have one hand free because you have to carry the thing around and it doesn't fit into your pocket. So it is pretty much the same situation as if the baby wasn't sleeping at all (but I have to admit that the baby monitor is much lighter than your average baby).

The solution for this problem is a 3D-printable belt clip. It snaps on the SCD560 phone but could fit other models as well. V1-3 print nicely with supports, no supports needed for V5. I recommend using >50% infill to make sure that the upper part is stiff enough. Have fun!

Difference between versions:

I added a new version (V5): Improved stability and prints great without supports. Tested with PLA and heavy cooling, printing in ABS failed due to warping

Version (V3): Improved stability of clip + optimized geometry + more rounded corners

Print Settings

Printer:

Felix 3.1

Rafts:

No

Supports:

Yes

Resolution:

100µm

Infill:

45%


Notes:

Printed at max speed to save some time.

Category: Household

Tagi