DM542T Stepper Motor Driver DIN Mount with SCUTTLE Binder Clip Retention
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the SCUTTLE robot v3's battery DIN mount to fit a DM542T Stepper Motor Driver.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a modification of the SCUTTLE robot v3's battery DIN mount to fit a DM542T Stepper Motor Driver.
The mount is held to the din rain using part of a 1 ¼" binder clip. Remove the binder clip handle, then bend it out slightly to make it wider, then squeeze it into the retention hole
2x M3x4x5 Heat set inserts are added to secure the motor driver
I recommend printing this in ABS or ASA, with 4 walls, 40% Cubic Infill, for maximum strength. It should be printed in the orientation that it comes in the 3MF, on its side, with Supports