1 / 5
Conical Sage Barista Espresso Collector Cup — zdjęcie 1
1 / 5

Conical Sage Barista Espresso Collector Cup

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Espresso collector cup for Sage 54mm diameter portafilters for a clean espresso preparing process.

Ocena
0 / 5
Polubienia
2
Pobrania
16
Wydruki
0
Wyświetlenia
187
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

The espresso collector cup for Sage 54mm diameter portafilter allows a clean way to fill the portafilter without distributing coffee where it should not be! The flexibel lid is used to grind coffee in front to accellarate coffee preperation later, such as in the morning or when guests are expected.
After the espresso has been ground into the cup, the portafilter is placed upside down on the cup and then flipped over. 

The cup has a cone on the inside for better distribution of the ground coffee after turning it over. The cone is a key feature by keeping the ground coffee in the middle of the portafilter.

Printing

Parts:

SageEspressoConeCup_v1.0

The first version which has a phase on the back.

SageEspressoConeCup_ergo_v1.0

New version with diagonally lines to increase the grip because the first version was a bit slippy when gripping it with the hand.

SageEspressoConeCupLid_v1.0

A lid to be printed in flexible filament as a seal on top to keep ground coffee fresh.

Tools and used printing parameters for the cup:

  • Printed in PLA.

  • 3 perimeters and 4 top and bottom layers to increase stability. The cup must handle a certain amount of mechanical force.

  • Support is mandatory.

  • 30% adaptic cupic infill.

  • Some tool to remove the support such as an small plier is necassary.

  • If necessary, smooth the guidance surfaces where the support was printed, so that the cup slides properly into  guidance of the the grinder. The matte surface from sanding can be changed back to a more smooth shiny surface by using a lighter afterwards and put the surface shortly over the flame.

If you have any comments, suggestions or similar, you are welcome to contact me.

Tagi