Purse Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I based the shape off of https://www.thingiverse.com/thing:2269715.
- Ocena
- 4,889 / 5
- Polubienia
- 225
- Pobrania
- 1253
- Wydruki
- 19
- Wyświetlenia
- 5625
- Oceny
- 18
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Women
- Licencja
- Creative Commons — Attribution
I based the shape off of https://www.thingiverse.com/thing:2269715.
The fact that their's has the forward angle forces the center of gravity towards the desk and thus keeps the hook on the table.
The issue I fixed with it is adding the rounded surface that the bag handle hangs from and also removed the angle that the lower "tail" had.
Personally, I add a thin layer of EVA craft foam, super glued onto the bottom of the portion that makes contact with the table, so as to prevent slippage and scratching.
I printed this with 3 layers at 1.5mm with 30% infill and it held up a 10lb backpack and barely had any popping sounds. Lay it on it's side in print setup and it won't require any supports. At least it didn't for me.
Print instructions
Category: Office Print Settings
Printer Brand: Wanhao
Printer: Wanhao Duplicator i3 Plus
Rafts: Yes
Supports: No
Resolution: 1.5
Infill: 30
Filament: Makerbot PLA Black