Thermaltake Core Series Punisher Fan Grill Panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Fan panel that will fit Any of the Thermaltake Core Series, this is a Core V1. The core series all use this…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Fan panel that will fit Any of the Thermaltake Core Series, this is a Core V1. The core series all use this part, AC-014-OO1OTN-C1, if it is a match then this will fit your case panel.
I have included 2 Panels, a Flat panel for Easy Remix. Also is the Translucent Style Punisher Panel, with a Smaller Face. The Black Style is NOT included, it is just a reference for what a solid Filament will look like when printed.
Tight tolerances, ensure your printer is set-up properly
READ ALL OF THIS
The Flat Panel is easy to print, no supports required, it is Face UP.
The Punisher Panel requires Supports, they are DIFFICULT to remove. You will need tool/s to help get them out of the groove, it will take about 30min.
I recommend the end of a small flat tool, the back of a small file was great. I also needed to punch out the holes using a 7/32 punch.
Normal PLA was much easier to remove the support than the Translucent, as the Translucent is a much harder material. I had the chisel out a few on the Translucent.
Fan holes are 120 x 120mm
Fan - Prolima Ultra Sleek Vortex 14, 140 x 15mm
This is installed above a Dark Rock TF, I have the fan installed as an intake. There is enough clearance, they do not touch.
Have fun Remixing, please Post Up!
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
No
Supports:
Yes
0.4
Infill:
100%
Notes:
SUPPORTS ARE DIFFICULT TO REMOVE, SEE NOTES ABOVE
Category: Electronics