1 / 6
Neptune 4 Plus Improved Y-Axis Belt Carriage (SF's Y Double Shear Mod) — zdjęcie 1
1 / 6

Neptune 4 Plus Improved Y-Axis Belt Carriage (SF's Y Double Shear Mod)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Y-Axis Belt Carriage for Neptune 4 Plus to be used with SilencedFrost's (SF) Y-Axis Double Shear Mod.

Ocena
0 / 5
Polubienia
5
Pobrania
33
Wydruki
0
Wyświetlenia
396
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Modified Y-Axis 9mm belt carriage based off clogged_nozzl3's design. 

The dimensions were adjusted to cater for clearance of the protruding double shear bearing mount in SilencedFrost's (SF) Y-Axis Double Shear mod for the N4Max. The Y endstop method of both N4Max and Plus are different, hence requiring a different belt carriage for the mod.

The carriage comes in two variants. 

  1. Screw In: You thread the hole with the stock belt carriage M4 screws directly. 
  2. Threaded Insert: You will need threaded inserts of M4 x 6(OD) x 7(H). 

Print settings:

  • Walls - 6
  • Top and bottom layers - 8 each
  • Infill 50-60% (no benefit going higher)

    Print in PETG unless you are very confident in your ABS print layer adhesion.
    Consider printing with brick layer configuration. Details below:
    https://github.com/TengerTechnologies/Bricklayers

3mm wide zip tie required to tighten around the belt locking loops to constrain them from expanding outwards under load.

The side L extension of the carriage is actually not necessary and is just there to utilize the extra M4 threaded hole right beside the mounting area. U can leave it unscrewed.
If u want to put a screw there, hold on to the part from beneath to ensure the part sticks flush to the bed frame, shown in the final photo. Use M4x14

Handsome guy SilencedFrost's profile: 

https://www.printables.com/@SilencedFros_2044064/models


Changelog

VersionRemarks
Beta (19 March 2025)Initial design upload
V1 Official Release (22 March 2025)Added basic variant, removed the unnecessary L side extension. L side extension variant is now optional.
V2Strength update. Tackled confirm issue of tensioner failing due to thin walls around the belt locking loop. Only updated the L side extension variant. 
V1 model deprecated, use with caution. Will be removed later.

Tagi