THE OBELISK-a minimalist retractable boxcutter (knife)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a simple minimalist knife featuring a compliant mechanism with easy assembly requiring a Stanley blade.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 377
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
about this model
this is a minimalist boxcutter designed with a comfortable side and a hole for mounting or just for fun . this design was inspired by ‘utility knife f1’ a great model you should also print (after this one)
this is the link to it here
designed for precision and to look ok in the rainbow of other tools
it uses a compliant mechanism for the lock as seen below⬇

I designed this model over the course of 4 days with numerous small tweaks in the mechanisms for the end stop , rails and locks.
print settings
for pt 1 of both left and right handed variants print at the following recomended settings
.no higher than o.2mm layer height
.3+wall loops
.3+ layers for top and bottom
.10-100% infill
.no supports are needed on these models
.for my ones I printed them out at 180 mm/s but at 60 mm/s for the first layer
.the filament I used for this model is pla linked here in orange
.printed with 190 degree c for the nozzle
.50 degree for the bed
for pt 2 of both left and right handed variants print at the following recommended settings
.no higher than o.2mm layer height
.100% infill
.no supports are needed on these models
.for my ones I printed them out at 180 mm/s but at 60 mm/s for the first layer
.the filament I used for this model is pla linked here in d matte dark grey
.printed with 190 degree c for the nozzle
.50 degree cfor the bed
assembly
just slide the stanley blade into pt 2 and into pt 1 simple
please upload makes it would make me very happy thanks
