Samsung refrigerator showcase door latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement door latch - static side - for a Samsung refrigerator "Showcase" door.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
If you find that the latch on your Samsung showcase door isn't holding anymore, it may be due to the static side of the latch being rounded/worn like mine was. I made this 3d print as an alternative to sourcing an original part.
Printed in PETG on an XL with organic supports. Tolerances are a little tight at 100% scale, but in a good way - ie not difficult to use/install.
Updated V2:
The version 2 file is an updated design where I have increased the size of the latch part so that it is both stronger and that it engages with the door side of the latch better, at least on my refrigerator. It is a tight install, so make sure you the latch itself positioned as tightly to the top as you can.
Suggested print settings:
- I suggest doing 30% infill, gyroid or 3D honeycomb for maximum strength in the directions needed.
- Bridging can work, but I would highly suggest supporting at least the latch head, so that you minimize bumps or rounded edges which could cause the door side of the latch to slip off. I might tweak this again in the future to have a slight wedge to counteract this.