AlfaRC Apex 2" FPV quadcopter frame printed accessories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TPU Accessories for the cheap 2" fpv frame from AlfaRC, called Apex 2. Feet, Camera mount, Antenna/XT30 mount, Buzzer
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 310
- Wydruki
- 0
- Wyświetlenia
- 1660
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Printed with 0.4mm Nozzle and 95 A Shore TPU, 0.15mm layer height.
Camera mount allows for 4 different mounting positions depending on hole used and orientation, which is a millimeter more to the front or to the back compared with the TPU part included in the kit.
Shoes should print with 0% infill for minimum weight and some shock absorption.Mine came out at 0.9grams/4pcs, much lighter than those included with the kit.
Cut the pillar on center with a sharp knife. To mount them, squeeze the sides and push the shoes over the end on the arms. If necessary, massage the 2 knobs into the hole on the arm with a flat screwdriver or similar.
Buzzer mount is for an active buzzer with 9mm diameter and ~4.2 millimeter height.
Antenna mount is meant to be cut open on the upper side with a sharp knife to insert the antenna cable.
For the XT30 adapter i used a drop of instant adhesive to secure the connector when disconnecting the battery.
Buzzer mount, XT30 adapter and antenna mount could fit other frames with 4mm hex standoffs and 14mm center to center.