1 / 3
Spacer for rear impellers (for wide bearings) — zdjęcie 1
1 / 3

Spacer for rear impellers (for wide bearings)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A spacer to give the rear most bearing a little more space, and prevent the rear impeller set from rubbing.

Ocena
5 / 5
Polubienia
3
Pobrania
46
Wydruki
1
Wyświetlenia
319
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

After assembling my second jet engine, I ran into the same problem in the first one. The bearings were just wide enough that the rear most impeller set wash squished against the stationary set. I tried carving away the face of the shaft and other things, but I couldn't make up the gap I needed. SO… i finally realized I already had a file that could be used to make an appropriate looking spacer. Easy Peasy!

Tagi