Universal DIN Rail Cover - DIN35
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
adjustable clip on holders to make cover / enclosure for din rail
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was inspired by @VladoOdribozi_798805 on this site but that did not have clips.
So i created holders for my rail. As I have a MeanWell transformer hanging off my DIN rail, it needed a fair size and ventilation.
PHOTO: only shows blue piece of cardboard to illustrate how thick plastic sheet or similar goes in. don't have one to hand yet.
This design allows for 1 housing frame at either end or more inside for more stability. The small clips hold any flexible sheet in the outer slot and can be any size to enable a gap at the top or bottom. The clips hold it in place and squeeze the outer edge closer to the inner one.
Additionally, for further stability, you can add the Housing Cross support which will clip on any part of the frame. use as many as you like (I use two). I added some notches at the bottom to make it easier to shorten if required.