Klipper Pressure Advance Tower V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A faster and easier to read, calibration tower for Pressure Advance in Klipper
- Ocena
- 4,909 / 5
- Polubienia
- 106
- Pobrania
- 3030
- Wydruki
- 15
- Wyświetlenia
- 8874
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
I prefer this model better than the original.
Lightweight, fast, & easier to read.
Print:
1 Bottom layer
0.2mm layer height
1 Perimeter
0 Top layer
0 Infill
Set all speeds to 100mm/s, except the first layer speed. Use your default value.
Important in Prusaslicer:
Under cooling: Set to 0 "Slow down if layer print time is below"
Otherwise 100mm / s cannot be achieved.
And
Turn off "Lift Z", during retraction, so as not to falsely trigger the TUNING_TOWER COMMAND .... procedure.
Continue the procedure.
https://www.klipper3d.org/Pressure_Advance.html
For Direct drive extruder, I prefer to use FACTOR = .01, instead of FACTOR = .005.
The precision is good enough anyway, and the printing time goes twice as fast until you find the sweatspot.