1 / 5
LED Light Bar for Ender-3 V3 KE/SE
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
LED Light Bar with hidden wiring, aluminum profile for improved light diffusion, heat dissipation and a reliable mount.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 235
- Wydruki
- 1
- Wyświetlenia
- 1966
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v2.0
SzczegółyPliki (20)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (47)Powiązane
My other Ender-3 V3 KE/SE parts & upgrades:
- LED Light Bar combined with Anti Shake Construction
- Raspberry Pi Case combined with Display Mount
- Raspberry Pi Expansion Board
About:
LED Light Bar with hidden wiring, aluminum profile for improved light diffusion, heat dissipation and a reliable mount.
Before you begin:
- This model is designed to fit the Lumines D LED profile.
- There is no cutout for the switch, as the type may vary depending on your choice.
- There are two versions of the Right section: with a Filament guide or without. Choose the one that fits your needs.
STEP-files are included, allowing you to remix the model to fit your LED profile and switch.
Build instruction:
- After printing the model, if you decide to install a switch, do so, then proceed with assembling the Left and Right sections. Insert Top 1 into the Bottom part first, followed by Top 2. The fit may be tight, so apply force if needed.
- Unscrew and remove the 3 screws from the top left part of the crossbar.
- Screw the Drilling template to the top left part of the crossbar and drill a 6 mm hole.
- Unscrew the Drilling template and throw it in the trash, as it will no longer be needed.
- Cut the LED profile to a length of 24.5-25.5 cm.
- Cut the LED strip to match the profile length, solder the wires, fit the heat shrink, insert the end caps, and attach the diffuser.
- Unscrew the 3 screws from the right side of the crossbar and remove the crossbar. Be careful not to lose the two washers! Pass the wire through the Left section, then through the hole in the crossbar and run it down along the Z-axis support.
- Turn the printer on its side and remove the bottom part. Catch the wire and pull it out.
- Crimp the wires into fork terminals and connect them to the available terminals on the power supply, ensuring proper polarity.
- Reattach the bottom part and return the printer to its original position.
- Reattach the crossbar, place the Left section on top, and secure it with 3 screws.
- Insert the LED profile into the slot on the Left section, then slide the Center section onto the LED profile.
- Slide the Right section onto the LED profile and secure it with three screws to the crossbar.
- Done, you're awesome!
If you've made it this far, you’ve probably made a make of my model. Feel free to share it with me and leave a comment!