The Rock - Triple Passthrough v3.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A triple helical passthrough of the Rock Johnson, with even more turns!!!
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A triple helical passthrough of the Rock Johnson, with even more turns!!!
You must print the entire object with automatic supports (also inside, not only in the printing plate), otherwise, it will be difficult to print it. If you decide to split it into parts and print them separately, it will also be very difficult.
After printing the object, you'll need to insert a thin sheet (e.g., the printing plate) between the helix and rotate it around the object to break the internal supports. You'll need to repeat this two more times (three times in total, for all three helix inter-spaces).
Once the three helix inter-spaces are cut, you'll need to apply some twisting force to finally break the remaining internal support bonds and finally separate the three helix. Finally, use a screwdriver or similar object to clean internal supports remains.
I did this with the following settings: 0.4 mm nozzle; 0.16 mm height; 15% gyroid infill; 2 wall loops. Material: PLA (should work with non-standard PLA and PETG).
The .3mf was created for BambuStudio. I don't know if it works in Cura and PrusaSlicer.