Gridfinity solder brass wool and moist sponge holder for soldering
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A convenient place to stuff your solder wool and your moist sponge, for use during soldering. 2x2 Gridfinity block.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here's a useful tool to get your soldering iron clean! It should fit the typical brass wool and sponge that ship in soldering iron station kits sold on AliExpress.
Print recommendation: the internal area will need supports, but avoid adding supports to the magnet and groove areas at the bottom, lest it not fit properly onto a Gridfinity baseplate or make it impossible for magnets to fit.
Two magnet sizes included in the 3MF and STL files:
- 6.5 x 2 mm
- 6.0 x 1.6 mm
You can change the magnet sizes in the FreeCAD FCStd file! Please note you'll need at least FreeCAD 1.0 as well as the Gridfinity workbench installed.
I recommend you waterproof the pocket at the top (for the sponge) using epoxy resin. Note the shiny pocket in the photo of the model — that's resin, which will prevent the plastic below from absorbing moisture from the sponge.
Please remember to never touch the plastic with the soldering iron, and to keep your sponge moist when working with it.