1 / 13
SkyWatcher Starquest 130p rack and pinion focuser replacement — zdjęcie 1
1 / 13

SkyWatcher Starquest 130p rack and pinion focuser replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SkyWatcher Starquest 130p rack and pinion focuser replacement that can be used for astrophotography

Ocena
5 / 5
Polubienia
3
Pobrania
25
Wydruki
1
Wyświetlenia
311
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The stock focuser on the SkyWatcher Starquest 130p Newtonian telescope is quite basic and not ideal for astrophotography. It is relatively tall, leaving limited back focus when trying to achieve focus with a camera, and it can feel a little wobbly.

This custom rack and pinion focuser is based on an existing design but adapted to fit the SkyWatcher Starquest 130p. The drawtube features an M42 thread, making it easy to attach a camera. I have successfully used this setup for astrophotography.

The focuser uses a pinion gear shaft that I purchased from AliExpress. The rack that came with the gear was too long for my needs, so I designed and 3D-printed a custom rack. While a 3D-printed rack is not the most durable solution, it is easily replaceable if it wears out.

The drawtube incorporates two steel or aluminum guide bars that slot into the top and bottom of the tube, along with the 3D-printed rack. No glue is required. These metal bars provide smooth bearing surfaces for the drawtube.

Equipment List

All bolts used are M3 DIN912 hex socket head bolts.

Drawtube

2 x 3x10x64mm steel or aluminum bars

3 x M3 16mm bolts

Focuser Body

4 x 3x8x3mm bearings

4 x M3 16mm bolts for the bearings

4 x M3 nylock nuts

4 x M3 nuts for the internal holes that secure the front plate

Pinion Block and Front Assembly

1 x pinion gear shaft (ordered from AliExpress, rack not required)

2 x springs, 4mm diameter, 6.5mm length, 0.42mm wire thickness

1 x M3 nut for the back of the front plate

1 x 3x10x37mm steel or aluminum bar for spring tension between the front plate and pinion block

4 x M3 16mm bolts. If you are fitting an autofocus bracket, you can instead use 2 x M3 25mm bolts with washers.

1 x M3 16mm or 18mm bolt for tension adjustment

Base

4 x M3 nuts. I paused the print at the correct layer to insert these nuts.

4 x M3 8mm bolts to attach the focuser body to the base.

The base is attached to the telescope tube using the same nuts and bolts from the original focuser.

Printing Notes

The only part that requires supports when printing is the focuser body. I printed most components in PETG for durability, but used PLA+ for the drawtube, as I did not have any black PETG available.

Final Setup

Once the focuser is installed, you will need to collimate the telescope. Collimation on the Starquest 130p can be challenging, as it does not come with rear mirror collimation screws. However, I found that by carefully loosening the screws holding the mirror to the telescope tube, it is possible to make small adjustments and achieve collimation.

Tagi