1 / 6
Plug for Porsche 987 Bose Subwoofer Retrofit
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed a way to plug in the Bose Subwoofer into a new wire harness as a retrofit... So I made this part.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Part uses available pins and plugs into the Bose 987 rear amplified subwoofer.
I printed with ABS solid with no infill. No Supports. For whatever reason I had to turn the plastic flow down a little from my normal to have the hole sizes not close in from design.
The 3 holes are to super glue ABS filament into them, so it is MUCH stronger against layer adhesion issues (needed)
Connector pins are: Molex Pin, Male & Female .093" 14-20 AWG. Can search on Amazon, etc.
I have a thread on Planet-9.
