Spice Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spice rack that uses 1/8th inch dowels to make up the bottom and includes a support for the center if needed.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
This is a spice rack that fits 1/8th inch dowels to make up the bottom and includes a support for the center if the wooden dowels are sagging. The center supports were also designed to be added after installation of the spice racks, so it you put them up and decide the center is sagging too much it is not a struggle to add the supports. The print doesn't need any supports, I used PLA but i would assume any other stiff material would work as well. For mounting I just used a couple of short #6 wood screws but just about anything should work, I would imagine even some command strips or double sided tape would probably hold but use at your own risk.
Print Settings
Printer:
FlashForge Finder
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
30% Hexagon
Filament:
eSun PLA+
White
Notes:
I printed with 3 walls and 30% infill but that might have been excessive for a spice rack