Oculus one handed stock longer version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's just a longer version of RDesign's remix which is a right hand shoulder support aka buttstock for the Oculus Quest2
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial
First upload, so go easy on me!
I extended the length of the stock by 75mm which makes the length from the back of the grip to the butt of the stock around 210mm (~8 ¼"). The total overall length is just over 279mm (~11") which just fits on a 220x220 bed.
My son plays a paintball game on his Oculus and wanted a buttstock for his controller. After I found and printed RDisign's, he played with it for a while but asked if I could make it longer so it was easier to use in different positions. So I extended the stock by 75mm which just fits on my Ender 3 v3 SE, at an angle from corner to corner.
I printed with a 5% gyroid infill and a wall line count of 3.
I would suggest printing with supports or the bottom turns out rough arounds the hole and edges.