Folded Wetsuit Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hanger to store wetsuits folded in half at the waist, instead of weighted on the shoulders.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 814
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
Hanging wetsuits on a traditional clothes hanger is a good way to wear out the shoulders, especially if you hang them up wet and heavy.
This is a design to hang a wetsuit folded over in half at the torso, where it's much stronger.
Assembled with 1/2" EMT conduit. The hook, printed on its side with an overhang, will be a tight press-fit on the conduit. I needed a rubber mallet to get them together. The coupler piece, printed on its end, is much more accurate and looser even with the .1mm clearance I gave it. I used a couple layers of kapton tape on the conduit to get a press fit.
My lower conduit is 18" and upper is 12.25". Feel free to shorten those if you like.
I printed mine out of CF nylon, and then galaxy black PLA when I realized the design is already way overkill structurally anyway, and the choice of filament I don't think is critical at all.
I suggest you print the coupler a few mm, cancel, and test-fit. Then you can adjust the tolerance in the source file accordingly depending on how accurate your printer is, since it's supposed to be a press-fit. The hook will be tight no matter what, due to the overhang and bridging on the inside of the hole.