Cutlass Buffer Tube Stock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact ergonomic collapsible stock for use with mil-spec buffer tubes
- Ocena
- 0 / 5
- Polubienia
- 51
- Pobrania
- 136
- Wydruki
- 2
- Wyświetlenia
- 1023
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the stock I am using on the yet-to-be-released Cutlass. The stock works well enough to be released before I release the rest of the blaster.
Hardware required:
1x 1/8" x 5/8" long dowel pin 90145A472
2x 1/8" x 1" long dowel pin 98381A475
1x 1/8" x 3/4" long dowel pin 98381A473
1x 1/4" OD x 1/2" long compression spring 1986K71
2x #6 x 3/8" thread rolling screws for plastic 99461A230
Update 1.1: Tightened dowel pin holes to prevent them from falling out. May lead to them needing to be drilled out, but that's better than them not staying in place IMO.
Update 1.2: Added sling point nobody asked for.
Update 1.3: Added QD cup and moved screws to better suit TPU buttpads.
Update 1.3.5: Added Magpul Type 1 and Type 2 kit compatibility with the alternate QD Stock Body print.
Update 1.4: Added another pin to secure the latch paddle from separating during use.
Update 1.5: Adjusted pin tolerances and fixed odd measurement, also added TPU printfiles