Simple Filament Rack for 1 inch Wood Dowels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print 4 of each piece and connect with dowels cut to length. Recommended dowel lengths: 24 in, 10 in, 3.5 in.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 321
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
For US makers, you can build this with 1 inch dowels cut to length. Print 4 of each part and assemble.
Depending on dowel tolerances, you may need to sand the ends a bit to fit. Consider also adjusting XY to -0.1 mm to make the holes a bit larger in diameter.
Bottom corners have feet, but these are not necessary. You could just print 8 top corners.
Recommended cut lengths: 10 in for vertical dowels, 3.5 inches for depth dowels, and 24+ in for width. Make as long as you want. Each hole is 1 inch deep, so account for that.
Print materials and settings are totally flexible. I don't think this needs more than like 5-10% infill but I would suggest slightly thicker walls.